MCS Software Manual

  1. Home
  2. MCS Software Manual
  3. Views and Controls
  4. Scaling Controls (2)

Scaling Controls (2)


If the view uses a non-decibel based Display Unit the default level controls will be replaced with an alternate set of scaling controls. Switching back to a decibel based Display Unit will also switch the controls back.

1. Upper Scale Boundary
Sets the numeric upper display bound of a view.

2. Scale Unit
Sets the actual Scaling factor, so if for example Scale Unit is “micro”, Scale Value is 5000 and Display Unit is Watt the view will show values from 0 to 0.005 Watt, using labels from 0 to 5000 microWatt.

3. Auto-Adjust Scaling Parameters
See Auto-Adjust Level Parameters

4. Enable / Disable Auto-Adjust
See Enable / Disable Auto-Adjust

Was this article helpful to you? Yes No