1. Home
  2. MCS Software Manual
  3. Views and Controls
  4. Marker Controls

Marker Controls

drex_marker_controls_screen

1. Open Marker Editor
Opens the Markers Editor dialog.

2. Save Markers
Store the current marker configuration on disk.

3. Load Markers
Reload a previously stored marker configuration.

4. Create 5 Maximum Markers
Replace the current marker configuration with 5 Maximum markers.

5. Center Minimum
Find the Minimum Peak in the current Spectrum view and set the Center frequency to it. This will reset the current sweep, so the peak may no longer be visible there.

6. Create Maximum Marker
Replace the current marker configuration with a single Maximum marker.

7. Create Minimum Marker
Replace the current marker configuration with a single Minimum marker.

8. Center Maximum
Find the Maximum Peak in the current Spectrum view and set the Center frequency to it. This will reset the current sweep, so the peak may no longer be visible there.

Was this article helpful to you? Yes No